Closing the box
Time required
Building: 30 minutes
Curing: 2 days
Tools required
Silicone
Silicone press
Tape
Parts required
Cover
glued box
Step 0: Check watertight seals
are all M-connectors tight and does every connector have an O-Ring?
is the O-Ring of the charging connector applied ?
is the "condom" of the switch applied and very tight?
is the "Motor-Kabeldurchführung" tight?
is the Weipu connector tight?
Have you performed the Setup and tetsting (open box) list?
Step 1: Apply silicone
Apply the silicone as shown in the picture. The string should be on the groove with a diameter of about 7mm as shown in the pictures.
Step 2: Pressing on the cover
After applying the silicone on the box you need to press on the cover. The silicone should come out on each side of the box.
Now you should get some tape and try to fix the cover to hold it down a little bit as shown in the picture.
Step 3: Sticking the GPS tower
For better GPS connention there is a 3D-printed tower for the GPS module. This one needs to be "glued" to the box with the silicone as well. For more details see pictures.
The tower needs to be attached with tape as well.
Apply Membrans
Requirements
Alcohol for cleaning and nerves
2x Membranes
First clean the surfaces with alcohol around the designated holes. Then apply the Membranes.
Finalization & Testing
For testing the waterproofness put the box into the bathroom and shower it. Don't forget to attach the membrane on the holes! While testing the waterproofness you should be connected to the Pi's to see the values of the DHT22 sensor.
Last updated