Receiver Software
Bind receiver to RC
Requirements
R-XSR receiver
connection cable to PixRacer <-> R-XSR receiver
X9D+ RC controller
Bind the receiver to the RC
If it doesn't work, update receiver as below!
Prepare the receiver
connect the receiver to the PixRacer (not powered)
while holding the small button on the receiver, turn on the PixRacer
All three LEDs are now on (not flashing)
Prepare the RC
Turn on the receiver
Press Menu
Choose the desired model
Press page (page 2 / 13)
scroll down to "receiver" / BIND
Press Enter
Press Enter (cf. Figure above)
The receiver will start peeping.
Immediately the red LED on the receiver should start blinking.
Press Enter to leave binding mode
Turn the PixRacer off and on - the LED of the receiver should light blue and green.
Press Exit twice to reach final testing.
Final Testing
Looks like this? Your're done!
If binding doesn't work: Update Firmware on the reciever R-XSR
If the receiver doesn't bind to the remote control, the firmware of the receiver and RC might be not compatible, the used receiver FrSky R-XSR might need a firmware update:
To flash the receiver you need:
Taranis 9D+
R-XSR
included connection cable
Modify the connection cable
On the included jumper cable, you have to swap the red (5V) and black cable (GND) as in the picture.
Upload and flash the firmware
To flash the firmware (frk file) you have to upload the file to your RC first. Either connect it via USB cable to your PC - or use the SD Card of the RC:
Upload the frk file to the "FIRMWARE" folder
you can download the firmware here: https://www.frsky-rc.com/r-xsr/
the current used version (EU-LBT) can be found here:
connect the receiver
turn on the RC
Long Press MENU
Press Page
choose "FIRMWARE"
choose the right FRK File
Long Press Enter
choose "flash external receiver"
press Enter
After flashing, try to BIND the receiver again.
Last updated