"Marriage" - combining box & fuselage
Time required
30 Minutes work
1 day to cure the motor mount glue
Tools required
UHU Por
Parts required
assembled Fuselage halfs
Check for Defects before continuation
are V-Tails glued in?
are the carbon pipes for Fuselage stabilization glued in?
is the motor glued in (in one side)?
are the Servo-Connectors tightly screwed on?
are all 3 motor connectors correctly attached (rotation direction of the motor)
are all 3 moter connectors secured with watertight shrink tube?
are all connectiots (V-Tail Servos, Motor plugs...) connected and secured?
Building Instructions
Prepare all parts
Apply UHU Por on both parts of the fuselage and the box (see red marks in image below) plus (new!) at the bottom of the box (for additional stability and to reduce water entering)
Spread equally and let it dry for 10 minutes until nearly dry
Only now put UHU on the motor mount (Yellow below) - it should NOT dry
Put the 2 parts together -
UHU Por is a "contact glue" - you can not move them after pressing them together
Why use wet glue on the motor mount?
The motor mount is inserted sidewards into the fusselage - if the glue is dry, its hard to get it in properly. UHU Por can also be used as a "wet" glue.
Finalization & Testing
Last updated