M8-Servo-Plugs
To connect the servos for ruders to the box, containing all the electronics, we use M8 connectors. These offer a small footprint and the required watertightness
Remarks for new M8 connects
Vtails
V-Tail to PixRacer internal M8 cable length: 24 cm
Wing to PixRacer internal M8 cable length: 14 cm
Cable code: blue signal, brown 5V, black GND
Cut M8 pre-made cable to 7 cm for V-tail
Cut the servo cable to 16 cm for the V-tail
Aileron
Cut the M8 Cable to 37 cm
remove about 15 mm outer isolation and 3 mm inner isolation
Route it through the designated cable hole in the fuselage, and attach it to a counterpart which is mounted in a box.
Insert the servo motor into the wing and hold the wing to the fuselage
if you are brave, cut the servo cable at the beginning of the uninsulated copper of the other cable
solder them together and apply shrinking tube
Final Product
2x F1
2x F2
4x F3
Requirements
Time required
Complete cable assebly set: 170 min
Preparation: 30 min
Building F1: 60 min
Building F2: 40 min
Building F3: 40 min
Tools required
Parts required
4x
4x
Preparation
Schrumpfschlauch und Kabel ablängen
Step by Step Guide
F1
F2
F3
Pin assignment
Tips and Tricks
Finalization & Testing
Outdated Manual:
Last updated
